Opus MasterPress 01 Operating, Maintenance And Health Safe Manual

Operating, Maintenance and Health Safe
Manual
MasterPress 01
Safety instructions:

Before putting the equipment into operation, please read the Health & Safety
precautions, manufacturer recommendations and the operation manual.

The user's guide should be easily available at any time for the operator.

The equipment should be fixed to the stand supplied and placed on a strong
solid flat level floor, to ensure safe operation. We recommended that you
screw down the base to the floor were possible.

The equipment should be protected against dust and moisture
= must not be placed near heating or ventilation units
= must not be used in vicinity of inflammable liquids or gases
= may be supplied with power only through the original cord.

A mains socket should be provided with in accordance with electrical and
earthing regulation.

The supply voltage should be consistent with the specifications on the
technical plate located on the machine housing and in the technical data
sheet.

Failure to do so may result in electrical shock or fire and cancel guarantee.

The electrical supply cable should be protected against damage, and must not
be used to pull the machine or to remove the plug from a socket

Making any changes to the electrical installation of the equipment or supply
cable can causes a fire hazard or electric shock and cancel the guarantee.

During long none use of the equipment, the plug should be removed from the
mains socket

Before removing the housing from the equipment, remove the plug from the
socket.

The electrical system is protected by a 8A fuse next to the power-switch at the
rear.

Before replacing the fuse, remove the plug from the mains socket.

When replacing the fuse it must be of the same type.

If the new fuse goes when replaced contact the service team.

Do not touch the heater – burn hazard!

Before fitting new typeface fonts in the frame wait for 5 – 10 minutes to make
sure that they have cooled down – burn hazard!

The equipment must be kept away from children and animals.

The equipment must not be used for any other purposes other than those
indicated in the user's guide

It is necessary to check that the equipment is being operated correctly. In case
of any malfunctions, contacting the service team is required.

The machine must not be located outside, should be operated in a room
o
temperature higher than 8 C

The equipment should be operated in accordance with general Health & Safety
rules

Any repairs can be made only by trained and qualified staff.

Do not use any solvents when clearing the equipment