Honeywell Bendix/King KMA 30 Manual page 13

drive another cabin speaker. If the PA mode is used with a microphone in proximity to an active cockpit
speaker, feedback might result.
To enable the PA discrete Output located at the rear connector, the internal configuration jumper, J4,
MUST be placed across both pins in the header. This jumper is shipped as open from the factory.
2.4.10.1 Public Address Output Jumper
1. Remove qty. 5 Phillip head screws from the PM8000B. NOTE: THE SCREW IN THE REAR
OF THE PANEL IS A DIFFERENT LENGTH THAN THE OTHER FOUR. YOU MUST
PUT THE SHORTER LENGTH SCREW BACK IN THE SAME LOCATION OR
DAMAGE WILL OCCUR. See Figure #1.
Figure 2-2 Screw Locations
2. Move the blue jumper located in the back corner near the sub-D connectors on both pins of J4.
See Figure #2-3.
200-890-5464
Bendix/King by Honeywell
KMA 30 Audio Panel and Intercom System
Installation and Operator's Manual
Long shaft screws
Short shaft screw
Page 2-6 Rev. 1, Aug. 2012