IKA MVP 10 basic Manual
  1. Manuals
  2. Brands
  3. IKA Manuals
  4. Water Pump
  5. MVP 10 basic
  6. Manual
IKA MVP 10 basic Manual

IKA MVP 10 basic Manual

Hide thumbs Also See for MVP 10 basic:
Table of Contents

Advertisement

Quick Links

20000004618
MVP 10 basic 022016
MVP 10 basic
IKA
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MVP 10 basic and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for IKA MVP 10 basic

Summary of Contents for IKA MVP 10 basic

  • Page 1 20000004618 MVP 10 basic 022016 MVP 10 basic ®...

  • Page 2: Declaration Of Conformity

    Source language: German Contents Page Declaration of Conformity Explication of warning symbols Safety instructions Correct use Unpacking Useful information Setting up Commissioning Maintenance and cleaning Accessories Troubleshooting Technical data Warranty Declaration of Conformity We declare under our sole responsibility that this product corresponds to the regulations 2014/35/EU, 2014/30/EU and 2011/65/EU and conforms with the standards or standardized documents: EN 61010-1 und EN 61326-1.

  • Page 3: Safety Instructions

    Safety Instructions • Read the operating instructions fully before starting up • Safe operation is only guaranteed with the accessories de- and follow the safety instructions. scribed in the ”Accessories” chapter. • Keep the operating instructions in a place where they can •...

  • Page 4: Correct Use

    The release of solvent vapors into the atmosphere can be vents. Use of IKA ® MVP 10 basic with these gases will avoided by fitting a downstream discharge condensation result in their condensing somewhere in the air flow of the trap.
  • Page 5 Setting Up Configurations: ® MVP 10 basic vacuum pump and vacuum controller connected to a vacuum load device. Recipient Vacuum Controller Magnetic Valve Pump control Inlet Outlet Mains power MVP 10 basic ® Electrical connections Vacuum hose Fig. 2 ®...

  • Page 6: Maintenance And Cleaning

    Do not allow moisture to get into the equipment when cleaning. Before performing a non-recommended method of clean- ing or decontamination, the user must ascertain with IKA ® that this method will not destroy the instrument. Maintenance •...
  • Page 7 - Item and designation of the spare part, formation of hazardous and/or explosive see www.ika.com, spare parts diagram and spare parts list. mixtures if a reaction between the air and the medium that is being pumped occurs Repair either within the pump or at its outlet.

  • Page 8: Troubleshooting

    • Use gas ballast valve to purge system of chamber condensates. Remove the vacuum hose to the gas inlet and open the gas ballast valve. Turn the pump on and run it at idle. • If problem persists, contact IKA ® service department. Knocking noise during pump Incorrect washer configuration assembled...

  • Page 9: Technical Data

    ETFE Outlet ETFE Subject to technical changes! Warranty In accordance with IKA ® warranty conditions, the warranty The warranty does not cover worn out parts, nor does it period is 24 months. For claims under the warranty please apply to faults resulting from improper use, insufficient care contact your local dealer.

Table of Contents