Using The Remote Control; Preparing The Remote Control For Use; Installing The Remote Control Batteries; Using The Remote Control To Operate Your Other Devices - Toshiba 26HF85 Owner's Manual

Using the remote control

Preparing the remote control for use

With the remote control, you can operate your TV, most cable TV
converters/satellite receivers, VCR and DVD player models together,
even if they are different brands. If you will be using your TV with a
Toshiba satellite receiver, VCR or DVD player, your remote control is
already programmed and ready to use. If you own different brands of
cable TV converters/satellite receivers, VCRs and/or DVD players, you
first have to program your remote control. (See "Programming the
remote control for use with a cable TV converter/satellite receiver, VCR
or DVD player" on page 17.)

Installing the remote control batteries

To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two "AAA" size batteries. Match the + and – signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.

Using the remote control to operate your other devices

To control a cable TV
converter/satellite
receiver:
Program the remote
control to recognize the
brand of your cable TV
converter/satellite receiver
(see "Programming the
remote control to operate
your other devices" on
page 17.) The buttons
shown at right will control
the cable TV converter/
satellite receiver.
Press "CBL/SAT" first.
J3S40121B(E)_P16-23 16
Power
Input (TV)
Mute (TV)
Channel
Numbers
CH RTN
(Channel Return)
Channel 3 4
CBL/SAT
Volume +/- (TV)
Pic Size (TV)
TV/VCR
16
Note:
The TV remote control may not operate your
VCR, DVD player, or cable TV converter.
Refer to the owner's manual supplied with the
applicable equipment to see which features
may be available. Additionally, the remote
control for this TV may not support certain
features available on the original remote
controls for such additional equipment, in
which case, it is suggested that you use the
original remote control for the applicable
device.
Caution:
• Never throw batteries into a fire.
Notes:
• Be sure to use "AAA" size batteries.
• Dispose of batteries in a designated
disposal area.
• Attention should be drawn to the environ-
mental aspects of battery disposal.
• Do not mix different battery types or
combine used batteries with new ones.
• If the remote control does not operate
correctly, or if the operating range becomes
reduced, replace both batteries with new
ones.
• If the batteries are dead or if you will not be
using the remote control for a long time,
remove the batteries to prevent battery acid
from leaking into the battery compartment.
To control a VCR:
Input (TV)
Program the remote
Power
control to recognize
Channel
the brand of your VCR
Numbers
(see "Programming the
CH RTN
remote control to
(Channel Return)
operate your other
Channel 3 4
devices" on page 17.)
Volume +/- (TV)
The buttons shown at
Pic Size (TV)
right will then control
the VCR.
Press "VCR" first.
VCR controls
24/02/2005, 6:06 PM
VCR