Specifications - Hitachi S 18SB Handling Instructions Manual

d) Use special care when working corners, sharp edges
etc. Avoid bouncing and snagging the accessory.
Corners, sharp edges or bouncing have a tendency
to snag the rotating accessory and cause loss of
control or kickback.
e) Do not attach a saw chain woodcarving blade or
toothed saw blade.
Such blades create frequent kickback and loss of
control.
SAFETY WARNINGS SPECIFIC FOR SANDING
OPERATIONS
a) Do not use excessively oversized sanding disc paper.
Follow manufacturers recommendations, when
selecting sanding paper.
Larger sanding paper extending beyond the sanding
pad presents laceration hazard and may cause
snagging, tearing of the disc or kickback.

SPECIFICATIONS

Model
Voltage (by areas)*
Power Input*
No-Load Speed
Rubber pad outer dia.
Weight (without cord)
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
Model
180 mm Sanding disc*
150 mm Sanding disc*
Rubber Pad
Wrench
Side Handle
* 1 Grain size : P50
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
<For Model S18SB>
180 mm Sanding disc
There are eleven different kinds of sanding disc, hav-
ing grain sizes of P16, P20, P24, P30, P36, P40, P50,
P60, P80, P100, P120. When placing your order, please
specify the grain size of the disc desired.
<For Model S15SB>
150 mm Sanding disc
There are eleven different kinds of sanding disc, hav-
ing grain sizes of P16, P20, P24, P30, P36, P40, P50,
P60, P80, P100, P120. When placing your order, please
specify the grain size of the disc desired.
Optional accessories are subject to change without
notice.
9
S18SB S15SB
1
1
1
—
1
1
1
PRECAUTIONS ON USING DISC SANDER
1. Keep away from a revoling sanding disc.
2. Pay strict attention to sparks.
3. Hold the disc sander firmly.
4. Do not leave the revolving disc sander unattended
on the floor.
5. Be careful those around one while operating.
6. Follow the procedures of these handling instruc-
tions on sanding disc replacement.
7. Never mount a depressed center wheel on this
tool and attempt to use it as a disc grinder.
S18SB
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
180 mm
APPLICATIONS
Sanding metal surfaces.
Preliminary sanding of metal surfaces before painting,
rust removal, removing old paint before repainting.
—
Finishing woodwork, correcting projections of tim-
1
bers from joints or assemblies.
Preliminary sanding of wood surfaces before apply-
ing paint.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, inviting serious
accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
CAUTION:
Damaged cord must be replaced or repaired.
S15SB
705 W
4500 / min.
150 mm
2.0 kg