Redial; Out Of Range; Call Waiting; Handset Earpiece Volume Setting - Toshiba FT-8801A Owner's Manual

BASIC OPERATION

REDIAL

Handset On The Base
1) Pick up the handset and press
2) Listen for the dial tone.
3) Press .
REDIAL

OUT OF RANGE

During a call, as you begin to move too far from the base unit, the
noise increases. Then, you should move close to the base unit. If you
travel out-of-range, your call terminates.(See page 19 "Interference or
static").

CALL WAITING

To use this feature, you must subscribe to the Call Waiting Service.
1
When you hear a call-waiting tone during your conversation on the
phone, simply press
2
To return to the first caller, press
NOTE:
FLASH
Pressing
current caller.

HANDSET EARPIECE VOLUME SETTING

To adjust the earpiece volume, press

HANDSET RINGER VOLUME SETTING

To adjust the ringer volume, press
mode.
18
TALK .
.
FLASH
without receiving a Call Waiting signal may disconnect the
Handset Off The Base
Press , then press
REDIAL
again.
FLASH
( or
VOL/RING
( or
VOL/RING
TALK .
) during a call.
) during standby