Table of Contents
Advertisement
2.
up/dOWN/ENTEr BuTTONS
•
Press the "dOWN" button for more than 1 second to change the displays top line. The rotary dial
changes the displays bottom line.
Example: The meter will display CO on its top line and temperature on its bottom line if you turn the
rotary dial to "TEMP" and push the "DOWN" button until CO is displayed on the top line.
•
Use the "up/dOWN/ENTEr" keys to change settings (such as time and date) when the rotary
dial is turned to "MENu".
3.
prINT/BACKLIghT BuTTON
•
Press and release "prINT/BACKLIghT" quickly to switch backlight on or off.
•
Press for more than 1 second before releasing to start the meter printing. The meter will display
"prINTINg".
4.
puMp ON/OFF BuTTON
•
The meter normally operates with the pump on. Press "puMp" quickly to switch the pump off
and on.
•
When the pump is switched off, the meter displays "puMp OFF" approximately every 30 seconds.
5.
FrEEzINg ThE dISpLAy
•
Press "hOLd/ENTEr" to freeze all readings. The display flashes and can be printed by pressing
"prINT" key. Press "hOLd/ENTEr" again for live measurements.
6.
MENu
•
Rotate the dial to "MENu" and use the "up" or "dOWN" buttons to select the following
function for change:
1.
Time - Uses "Military" time as standard: 7am = 07:00, 7pm = 19:00
2.
Date - Select from MM/DD/YY, YY/MM/DD or DD/MM/YY
3.
The display's top line - select from the settings listed below
4.
Temperature units - ˚F or ˚C
5.
The display screen contrast
6.
Language - select from English, French, Spanish, Italian and German
7.
Service - Password protected for authorized service personnel only
•
When you have selected the function to change, press "ENTEr" to select.
Repeat this as the menu "drops down" to select (using the "ENTEr" key) and change (using the
•
"up" and "dOWN" keys) the function. The final, logical "ENTEr" returns you to the main
menu display.
•
To exit the menu function at any time, rotate the dial to another position - Unless the final logical
"ENTEr" is pressed, no changes are made.
7.
Time & date
8.
Temp:
Displays the measured temperature in ˚F or ˚C.
•
If the temperature sensor is broken or open circuit it displays 000.
9.
CO:
Displays Carbon Monoxide (CO) values in PPM.
10. CO MAX:
Displays the maximum CO value in PPM recorded during the test
: Displays time and date.
5
Advertisement
Table of Contents
