Advertisement
Quick Links
OPERATING INSTRUCTIONS FOR SYMCOM'S
INFORMER OPERATION
The Informer is a handheld diagnostic tool for use with single-phase PumpSaver
®
PumpSaver
Plus models equipped with infrared LED transmitters. The Informer receives
and displays data sent from the PumpSaver
system.
1.
Verify power is applied to the system and the PumpSaver
(Refer to the PumpSaver
RUN light should be illuminated, indicating conditions are good and data is being
transmitted.
2.
Press the ON button to activate the Informer, and point it toward the PumpSaver
The green COMM STATUS light will turn on, indicating data is being received.
INFORMER
3.
Use the SCROLL buttons to view the PumpSaver's various operating parameters. If
the data signal is interrupted, the Informer will hold the last values it received before
communication was lost.
4.
The Informer will automatically turn off if the scroll buttons are not pressed for 2
minutes.
NOTE: Simultaneously pressing both scroll buttons will display the firmware revision
number and also initiate the auto-off sequence.
NOTE: A battery check is performed each time the Informer is turned on. "Low
Battery!" will appear indicating it should be replaced.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
INFORMER
DIAGNOSTIC TOOL
®
, which can be helpful for troubleshooting the
®
installation manual for calibration instructions.) The green
Figure 1: Informer Operating Distance
®
has been calibrated.
1 - 8 FT.
20 º
®
and
®
.
Advertisement
Related Manuals for SymCom INFORMER
Summary of Contents for SymCom INFORMER
- Page 1 Figure 1: Informer Operating Distance Use the SCROLL buttons to view the PumpSaver’s various operating parameters. If the data signal is interrupted, the Informer will hold the last values it received before communication was lost. The Informer will automatically turn off if the scroll buttons are not pressed for 2 minutes.
-
Page 2: Operating Parameters
OPERATING PARAMETERS By using the scroll buttons, each of the PumpSaver’s operating parameters can be displayed. following screen examples descriptions each parameter (shown in the order they are displayed when using the scroll down button). ® NOTE: PumpSaver Plus screens will be hidden when communicating with standard PumpSavers. - Page 3 A m p s Overload Trip Screen: Displays the current drawn by the pump motor and the overload trip point. Line Amps: This feature eliminates the need for an ammeter, and will help determine if the pump is drawing acceptable amperage ®...
- Page 4 2 3 0 V A C i m e 3 2 d 5 7 m ® Fault History Screens*: Displays the last 20 faults** of the PumpSaver Plus (standard ® PumpSaver models and older Informers will only display the last fault information). The fault screens display kW, line voltage, and Amps of the motor at the time of each fault;...
-
Page 5: Troubleshooting Guide
The displayed values fluctuate radically. directly at the PumpSaver’s infrared LED and is within the operating distance (see Figure 1). This Is Normal - The Informer holds the last The Informer displays values even after values it received before communication was communication is lost. - Page 6 SymCom. All custom and private labeled products are warranted for eighteen (18) months unless otherwise stated in writing. The liability of SymCom is limited, at its option, to replace, repair, or credit at the purchase price, for any devices which are returned during the warranty period and which prove to be defective.
Need help?
Do you have a question about the INFORMER and is the answer not in the manual?
Questions and answers