Table of Contents
Advertisement
Quick Links
INFORMER MS OPERATION
The Informer MS is a handheld diagnostic tool designed for use with MotorSaver
455s equipped with infrared LED transmitters. The Informer MS receives and displays
®
MotorSaver
data to assist in monitoring and troubleshooting the system.
An auxiliary kit is available which allows the Informer MS to read data from a panel-
mounted Model 455 without opening the panel door.
Note: See page 7 for more information about the IR kit and to determine if a Model 455
is compatible with the Informer MS.
1.
Verify power is applied to the system. Refer to the MotorSaver
instructions for installing and operating the Model 455.
2.
Press the ON button to activate the Informer MS and direct it toward the
MotorSaver®. The green COMM STATUS light will turn on, indicating data is being
received.
3.
Use the SCROLL buttons to view the
MotorSaver's operating parameters. If the
data signal is interrupted, the Informer MS
will hold the last values it received before
communication was lost.
4.
The Informer MS will automatically power
off if the scroll buttons are not pressed for
2 minutes.
Note: A battery check is performed each time
the Informer MS is turned on. "Low
Battery!" will appear when the battery
needs replacing.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Operating Instructions for SymCom's
INFORMER MS EDITION
DIAGNOSTIC TOOL
Figure 1.
®
Model
®
installation
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SymCom INFORMER MS
Summary of Contents for SymCom INFORMER MS
- Page 1 MotorSaver data to assist in monitoring and troubleshooting the system. An auxiliary kit is available which allows the Informer MS to read data from a panel- mounted Model 455 without opening the panel door. Note: See page 7 for more information about the IR kit and to determine if a Model 455 is compatible with the Informer MS.
- Page 2 ® Real-Time Counter: When the MotorSaver determines the voltage is high, low or unbalanced, it begins a trip counter that will be displayed by the Informer MS. Once this ® counter reaches the trip delay setting, the MotorSaver will trip off.
- Page 3 R e a l T i m e C n t = Restart Delay Screen: Displays the restart delay setpoint and restart delay timer. Restart Delay Setpoint: The Informer MS displays the exact restart delay setting which ® corresponds to the position of the dial on the MotorSaver ®...
- Page 4 R u n T i m e : R u n n i n g 2 8 m ® Run Time Screen: Displays the status of the MotorSaver and the total motor run time. ® MotorSaver Status: The following codes may be displayed: §...
- Page 5 2 0 h 1 4 m Motor Start Screen: There are 32 possible motor start screens. The Informer MS will display the time of each of the last 32 motor starts with #1 being the earliest start and #32 being the latest (most recent) start.
- Page 6 MotorSaver’s IR LED and the display values fluctuate radically. is within the operating distance (see Figure 1). This Is Normal – The Informer MS holds the The Informer MS displays values even after last values it received before communication communication is lost.
- Page 7 Model 455 and to the outside of the panel to allow communication without opening the panel door. The part number for this infrared kit is Informer MS IR Kit and is available at a nominal cost. SymCom warrants its microcontroller-based products against defects in material or workmanship for a period of five (5) years from the date of manufacture.
Need help?
Do you have a question about the INFORMER MS and is the answer not in the manual?
Questions and answers