Page 1
For assistance, call 1.877.306.8930; for U.K 0800.031.4069: e-mail at info@newageproducts.com. ATTENTION : Is your cabinet damaged? STOP Need help or spare parts? For fastest service, contact NewAge Products at 1-877-306-8930; or support@newageproducts.com. Do not return to the retailer.
Page 2
Unpacking • Begin by placing the package on a protected flat surface. • Remove all cardboard, foam packaging material and clear plastic bags. • Dispose / recycle all packaging materials. • Verify all the contents in the box and gather the required tools. See “Parts Supplied”...
When this product is installed, operated and maintained according to the instructions attached to or furnished with the product, NewAge Products Inc. will replace the defective product or parts if the part fails as a result of defective materials or workmanship for a period of one year from the date of purchase.
Page 4
Removing Drawer Press plastic triggers on underside of Extend drawer fully. drawer according to arrows in image. Unfasten and remove both the Tilt and remove drawer. drawer face and the handle. Preparing Cabinet for Sink Installation Measure and mark opening to be Unfasten and remove left and cut in cabinet top with a pencil.
Page 5
Connect all four corner holes using a Drill a 1/2” hole in each corner of jigsaw by cutting along the marked lines. the marked opening. Use 2.0mm spacers and align the Fasten tip-out hinges to cabinet using drawer edges with the edges of four M3 x 14mm screws for each hinge.
Page 6
Preparing Countertop for Sink Installation Measure and mark opening to be cut in countertop with a pencil. Connect all four corner holes using a Drill a 1/2” hole in each corner of the jigsaw by cutting along the marked lines. marked opening.
Page 7
Drill 4, 3/32” pilot holes on Tighten screws to secure cabinets. interior roof of cabinet.
Page 8
Installing the Sink and Faucet Remove sink and use 1-3/8” Insert sink into opening and trace circular saw to cut faucet hole. faucet hole. Insert the drain body into drain Apply a thin bead of plumber’s putty opening and press into to the perimeter of the drain plumber’s putty.
Page 9
Insert sink into opening and ensure front Apply silicone to bottom edge of edges of sink and countertop are parallel. sink using a caulking gun. Attach the braided hoses to the Apply a small bead of silicone to faucet assembly. the perimeter of the sink.
Page 10
Fasten the (red) hot water braided From the inside of the cabinet add hose to the hot water intake angle the sealing gasket, metal washer and valve, and the (blue) cold water tighten the plastic fastening sleeve. braided hose to the cold water intake angle valve.