Maintenance; Electrical And Mechanical Irregularities; Error Messages - Primer LS -11 P User Manual

Washer extractor

Hide thumbs

Table Of Contents

Table of Contents

5.1

Electrical and mechanical irregularities

Before calling the Technical Service Centre, check the

following:

That power is supplied to the machine.

The condition of the fuses.

That the voltage is correct for the machine.

If the washing machine fails to get the required

level of water, check:

The water mains tap is open.

The water inlet filter is not blocked.

That the water pressure is between 2 and 4 kg/cm 28

(28 and 56 psi).

If the washing machine vibrates excessively,

check:

None of the panel screws is loose.

Message

Possible causes

This message appears on recovering the power after having been cut-off.

PWR FAUL

If the power cut occurs during the spin cycle, the message "WAIT" is

UAIT

displayed. For safety reasons, wait approximately 1.5 minutes without

pressing anything until "PWR FAULT" is displayed.

FAULT LOCK

This message appears when it is detected that the door can not be unlocked

at the end of the programme or that it has unlocked during the programme

FAULT DRAIN PIPE

This message is displayed when, in spite of deactivating the emptying valve

output, the water level inside the drum has not decreased for a pre-

established period of time.

FAULT WATER INLET

This message appears when, in spite of activating the corresponding

solenoid valves' outputs, the water level inside the tub has not increased

during a certain pre-established period of time.

HEATING FAULT

This message is shown when, in spite of activating the heating output, the

water temperature has not increased for a certain pre-established period of

time.

MAX. TEMP

This message is displayed when the water temperature has exceeded 95 ºC.

THERMOSTAT OPEN

This message appears when the water exceeds 95 ºC

MOTOR HEATING

This message appears when the thermal protection of the washing

machine's motor is detected to have not been activated.

UNBALANCE

E10

This message appears when the final spin activates the unbalance micro

three times.

CLOTHES HOT

E11

This message is displayed when a programme execution finishes but the

water temperature inside the tub exceeds 50 ºC.

WATER IN TUB

This message is displayed when a programme execution is finished but there

E12

is still water inside the tub. The door can not be opened until the water is

drained from the tub.

5 MAINTENANCE

If a power cut occurs, check:

The tub is drained and the door is blocked. If you want

to take the clothes out of the washing machine, unlock

the door by pulling down the belt located behind the

front panel.

5.2

On the washing machine screen, warning or fault

messages may be displayed during or after the

execution of a wash programme. Except in the event

of a power cut, the washing machine will be paused

(drain pipe valve off, motor off, etc.), awaiting user

action.

Error messages

Action

Press START: the programme continues to

operate in the same phase as before the

power cut.