Global Reset - Niko 05-350 Manual

05-350 / 05-338
3.2. Programming, teach a transmitter
1. Apply 1 brief (<1.6s) press to the
2. Use the button to switch ON the desired channel on the receiver.
3. Select the function (see function table) using the
4. Select the relevant times (see time table) using the
5. Press the push button to be programmed on the hand-held transmitter or wall-mounted
transmitter. This is acknowledged by a short bleep signal. Different transmitters can be
programmed. If the memory is full, you will hear a long 2s bleep tone.
6. If you select a function with 2-button or 4-button control via 'mode', you only need to press
one of the buttons. E.g. for mode 1 you only need to press the button at the top or bottom
to carry out the programming.
7. Apply a brief (<1.6s) press to
noTe: Additional transmitters (max. 32) can at any time be programmed on a receiver: repeat
'PROGRAMMING'. If the memory is full, you will hear a long 2s bleep tone.
The programming is retained in case of prolonged power failures.

3.3. global reset

1. Apply 1 long (>1.6s) press to the
sounds.
2. Apply a second long (>1.6s) press to erase the complete memory.
EN
prog.
button, a bleep signal sounds.
prog.
to end the programming.
prog.
button until the special repetitive bleep signal
rotary switch.
rotary switch.
43