Advertisement
Please read the following safety and
operational information throughout
before using this item
FILLING THE GAS CANISTER
Upon initial use, the torch may require one charge/
discharge cycle before achieving maximum capacity.
Warning: Avoid Flames and Sparks when discharging
gas from the unit. This torch uses standard butane
fuel. Fill the torch in a well-ventilated room, away
from any open flame.
Turn the torch off and make sure the flame is out.
Let the torch cool at least 5 minutes
before filling the cylinder.
Hold the torch upside down and insert the can's
nozzle into the Gas Filling Valve.
Press the nozzle into the valve to release the gas.
Once the gas begins to seep out around the edge of
the nozzle, the torch is full and you should remove
the can.
CONTENTS UNDER PRESSURE.
Contains flammable gas under pressure. Do
not use near sparks or open flame. Do not
puncture or incinerate container or store at
temperature above 120°F.
Keep out of reach of children.
ELECTRONIC MICRO TORCH KIT
Page 2
Figure 1
1. Center the Gas Adjustment Dial between the "-"
and "+" signs.
2. Rotate the Air Adjustment Ring to half expose
the air holes.
3. Use your thumb, and pull down the Safety Switch.
(see Figure 1)
4. To Light the Torch:
press and hold down the Ignition Button. (It may
take two or three tries before the torch ignites.
Each attempt will require pulling down the Safety
Switch, them pressing the Ignition Button again.)
button, press/shift the Continuous Flame Button
with a finger or thumb of your free hand.
(see Figure 2)
Adjustment Dial and the Air Adjustment Ring.
5. To turn the torch off, press the Ignition Button to
release the Continuous Flame Button. This will cut
off the gas supply and extinguish the flame.
MPTK76
REFILLING GAS
Figure 2
1702058-14 MA
Advertisement
