Related Manuals for Evolur Infinity 478
Summary of Contents for Evolur Infinity 478
- Page 1 MODEL NO.: 478 USER MANUAL Important: Keep these instructions for future reference. Safety Cozy Fashion...
- Page 2 WARNING Thank you for choosing Dream On Me and congratulations on joining The DOM Family, a family that has been transforming lives for 30 years! We appreciate your feedback and wish you the very best in the coming years with your new addition. If you have any questions or concerns please don’t hesitate to reach out and a trusted DOM representative will assist you.
- Page 3 WARNING THE STROLLER IS DESIGNED FOR USE ON FLAT OR GENTLY SLOPING SURFACES, AND MAY BE UNSTABLE ON HIGHER SLOPING AND UNEVEN SURFACES. USERS SHOULD BE AWARE OF THE POSSIBILITY OF THE STROLLER ROLLING AWAY OR TIPPING OVER. • PUSH THE STROLLER HOLDING BOTH HANDS. •...
-
Page 4: Care And Maintenance
• Always check parts regularly for tightness of screws, nuts, and other fasteners. Tighten if required. To maintain the safety of your Infinity Stroller, seek prompt repairs for bent, torn, worn or broken parts by contacting Evolur. Dream On Me Inc. 1532 S Washington Ave, Piscataway TWP, NJ 08854... -
Page 5: Parts List
Parts list Please check to make sure that all of the following parts listed are included in the box when opened. If there are any missing parts, please contact Evolur before using the Infinity Stroller. Fold Handle Canopy Handle Bumper Bar... -
Page 6: To Open Stroller
1. To Open Stroller (1) Open storage latch, refer to Fig. A (2) Lift up the handle of stroller, refer to Fig. B & C (3) Hold the Gray Lock Pedal, then lift handle of stroller up until hear a “Click”, refer to Fig D. CHECK that the stroller is completely latched 咔嚓... - Page 7 2. Front Wheels (4) Slide each front wheel into the mounting post at the front of the stroller until you hear a "click" (Fig. A). Pull each wheel to CHECK and ensure that they are secure. For easy transport or storage, Push the wheel release tab on the inside of the stroller frame and pull the wheel off of the stroller (Fig.
-
Page 8: Using The Brakes
4. To Use Bumper Bar (6) Assembling and removing the Bumper Bar: Push the bumper in each slot to install until it clicks into place, as shown in Fig A. Press the buttons on the sides of the Bumper Bar together and pull it off to remove it, as shown in Fig B. -
Page 9: Footrest Height Adjustment
6. Swivel Wheel (8) Push the swivel lock switch down to lock the front wheel in position. Push the swivel lock switch up to allow the wheel to swivel. 7.Footrest Height Adjustment (9) Pick up the foot rest to higher position, as shown in Fig. - Page 10 8. FOOT BARRIER WARNING: For 0 ~ 6 MONTHS BABY, THE FOOT BARRIER HAVE TO BE USED. (10) The Foot Barrier is under the Footrest, take it out as shown in Fig. A. Put the bumper bar go through the Foot Barrier, then attach the bumper bar to stroller frame, as shown in Fig B.
-
Page 11: Adjusting The Backrest
9. Adjusting The Backrest (11) Adjustment of the reclined and upright position: Pull the 2 straps as shown in Fig. A to make the backrest move to the upright position. Pull down the buckle as shown in Fig. B to recline the backrest. - Page 12 10. Securing Your Child To The Harness WARNING: USE THE HARNESS AT ALL TIMES. When not in use, disconnect shoulder straps from the waist strap and buckle to prevent strangulation. A five point harness is provided to restrain your child. Buckle tongues separate for added safety.
- Page 13 11. Securing Your Child To Harness (14) Tighten or loosen shoulder and crotch straps by sliding up an down the bar sliders (Fig C). (15) To tighten or loosen the waist straps, hold and lift the 4 bar sliders, then pull the harness strap to adjust to the desired fit. The waist strap needs to fit firmly around the child (Fig D).
- Page 14 12. Securing Your Child To Harness (17) To release the buckle, squeeze the top button on the buckle housing with enough pressure so that the buckle tongues can be released (Fig. F). CAUTION: DO NOT SLIDE 3 BAR SLIDER OVER THE SEWN TAB ON SHOULDER HARNESS.
- Page 15 13. To Fold The Stroller Note: before folding, make sure that the stroller is in the upright position. (19) Squeeze the button 1 and then squeeze button 2. Then, fold the handle bar downward (Fig A/B). (20) Pull the handle towards the back of the seat, and then forward into the seat as shown in Fig.
- Page 16 (21) Pull up on the handle and let the frame collapse. (Fig E). Handle (22) Make sure the storage latch clicks into place. Stroller can stand up after fold (Fig F). 14. To Lift and Carry The Stroller To lift or carry the stroller, ensure that the storage latch is engaged.
Need help?
Do you have a question about the Infinity 478 and is the answer not in the manual?
Questions and answers