Advertisement
Quick Links
Instructions of shipment, unpacking and installation.
General scheme of the awning
G ui de
Steering:
[ ] Manual,
[ ] E-drive,
Data of electric drive:
Power ..................... W, Voltage 230V;
Frequency 50Hz;
Data from the additional drive/lighting:
Power ..................... W, Voltage 230V;
Frequency 50Hz;
YOC: .................................................
Serial Number: ..................................
CAUTION!
These instructions must be read and understood before installation, adjustment,
service or maintenance.
Operations and Maintenance,
Pergola PRO awning
Fa bric
Ro of
Cr ossb ar
P ila r
.......................................
EN 13561
External blinds
Class of wind resistance:
.......................................
page: 1 / 20
Advertisement
Related Manuals for Jalousie-Welt Pergola PRO
Summary of Contents for Jalousie-Welt Pergola PRO
- Page 1 CAUTION! These instructions must be read and understood before installation, adjustment, service or maintenance. Operations and Maintenance, Instructions of shipment, unpacking and installation. Pergola PRO awning General scheme of the awning Ro of Fa bric G ui de Cr ossb ar...
- Page 2 page: 2 / 20 Content 1. Introduction 2. Instructions for use and maintenance 3. Transportation, unpacking and installation instructions Introduction These installation instructions are an integral part of the awning and was written for the professionals of the installation company and for the end users. An additional instruction for the electric products will be attached to this manual and should be treated as an integral part of this instruction.
- Page 3 page: 3 / 20 Use and Maintenance instruction 2.1. General CAUTION! For the reasons of safety, installation, maintenance and use of awnings, please follow the following guidelines. The installation of the awning should be done by an authorized dealer. Modifying the construction of the awning are not allowed. It is not be allowed to under awning be during maintenance or installation work.
- Page 4 page: 4 / 20 In an area with high wind intensity that is exposed to a frequent power cuts, we recommend to use an alternative energy source, or to use a handle. When it comes to awnings that can be to switch on out of the sight, the user should take the appropriate organizational measures so as to prevent unintentional switching of the awning during maintenance or repair work, eg window cleaning or wall cleaning.
- Page 5 page: 5 / 20 2.6. Important notes and warnings CAUTION! Roll up the awning in bad weather such as frost and snow. CAUTION! If the awning will be used during the frost it can be damaged. Note Possible buckling of the fabric. In the vicinity of the seams and the edges of the sheathing can form folds and wrinkles - it is natural.
- Page 6 page: 6 / 20 Do not dispose of electrical components in the trash. It must be deliver to the point of disposal of electrical equipment.
- Page 7 7 / 20 Instructions of shipment, unpacking and installation 3.1. Delivery 1x Pergola awning Type: Pergola PRO, Brackets: wall/ceiling brackets 2 or 3 pcs. Ground brackets together with pilars 2 or 3 pcs, 1x Service Manual, 1x Operating and Maintenance Instructions, Warranty,...
- Page 8 page: 8 / 20 3.3. Service, shipment, unpacking and storage The awning is so packed that it can be delivered without damage. During loading and unloading of the awning be sure it was not placed on an uneven surface. Upon unpacking the product you keep a special care not to damage the fabric.
- Page 9 page: 9 / 20 3.8. Installation steps 3.8.1. Check the delivery. 3.8.2. Mark and fix the mounting brackets. 3.8.3. Laying electric cables (if motor drive was ordered). 3.8.4. Fix the pergola awning frame. 3.8.5. Screw the crossbars to the trolleys; check operation of awning. 3.8.6.
- Page 10 page: 10 / 20 Right side 12,4 12,4 1 5,6 B1 ‒ projection on the floor C ‒ pilar high...
- Page 11 page: 11 / 20 Note When selecting the mounting means that the maximum load on the awning is 132 N/m². In addition, you will be taken into account the weight of the awning, which is ca. 7 kg/m². 3.8.3. Laying electric cables (if motor drive was ordered) Drill out grommet for electrical conduit.
- Page 12 page: 12 / 20 In the case of two modules pergolas (3 posts ) act as a one-module for pergolas . The next step is to put electric propulsion with electric drive. If you order an electric drive or gearbox attachment with the transfer of the drive. The case of the electric drive.
- Page 13 page: 13 / 20 Install roof. To do this, install in peak profiles 11 D in places as shown on the drawing. Visor shaped sheet screwed "overlap" the special screws (farm ) to profiles 11 and 11D . 3.8.5. Screw the crossbars to the trolleys; check operation of awning CAUTION! For correct operation of the awning, it is necessary that the side profiles are perfectly parallel to each other, and the connection between the front profile and trolley are...
- Page 14 page: 14 / 20 Sequentially attach cross sections (16) to trolleys by inserting slider (17) to the wheels (18) extending from the trolleys and lock pin (19) in the ankle plate (20) by the screws (21). Lock the screws (22) in the sliders (17).
- Page 15 page: 15 / 20...
- Page 16 page: 16 / 20 3.8.6. Water blockade and gutter system wa ter flooding side view front view Gutter system Water blockade on sides...
- Page 17 page: 17 / 20 gutter water pipe pilar special bracket concrete C20/25 Special bracket for the gutter system 3.8.7. Perform electrical installation (only for motor drive) CAUTION! The electrical connection must be performed by a licensed professional. Connect the electrical wires according to the circuit diagram. The awning may only be connected if the specifications on the type plate agrees with your power source.
- Page 18 page: 18 / 20 Fabric open Fabric closed...
- Page 19 page: 19 / 20 3.8.9. Couple of handle (only manual drive) Awnings handle into the loop of the gearbox. By turning the handle can open or close the awning. Awning fabrics must be roll up on the right side (from top) otherwise it can damage the sheathing and the awning.
- Page 20 page: 20 / 20 3.10. Start-up Any person can't stay in the area of the awning during the test run. All items located under the awning must be removed. The remote control can be used only if the user see the awning in the whole range of its movement.