Hardware Installation - Precision Flight Controls Cirrus Desktop Yoke User Manual

3 HARDWARE INSTALLATION

PACKAGING CONTENTS:
(1) USB CIRRUS YOKE
(1) 6 FOOT USB CABLE
(1) 24 VOLT POWER SUPPLY
(1) USER'S GUIDE
(1) USB FLASH DRIVE
PACKAGE INSPECTION
CHECK PACKAGING FOR DAMAGE. DO NOT UNPACK DEVICE IF THERE
ARE ANY DAMAGE IN THE PACKAGING. IMMEDIATELY REPORT ANY
DAMAGE TO THE CARRIER AND PFC TECHNICAL SUPPORT. TAKE CLEAR
PICTURES OF THE DAMAGE AND EMAIL THEM TO
TECHSUPPORT@FLYPFC.COM.
ORIGINAL PACKAGING
PLEASE KEEP THE PACKAGING OF YOUR DEVICE UNTIL THE
WARRANTY IS NO LONGER IN EFFECT. THE ORIGINAL PACKAGING IS
THE BEST PACKAGING SHOULD IT BECOMES NECESSARY TO SEND THE
UNIT TO PFC.
COMPATIBILITY
THE CIRRUS YOKE IS COMPATIBLE WITH MS-FSX, PREPAR3D AND X-
PLANE 9 AND 10.
INSTALLATION
1. IF THERE ARE NO DAMAGES, CAREFULLY LIFT THE DEVICE OUT OF
THE BOX.
2. SET THE YOKE ON TOP OF YOUR TABLE OR DESK.
3. CONNECT THE SQUARE END OF USB CABLE TO THE BACK OF THE
YOKE.
4. CONNECT THE FLAT END OF THE USB CABLE TO THE COMPUTER.
5. CONNECT THE POWER CONNECTOR FROM THE POWER SUPPLY TO
THE BACK OF THE YOKE.
6. PLUG THE POWER SUPPLY TO THE AC SOCKET.
DC
USB
POWER
24 V Power
Supply
ETHERNET
For Connecting
Control Loading
Pedals Only
To USB Port on
your computer