Cleaning And Maintenance - Helios Ardes Instructions For Use Manual

INSTRUCTIONS FOR USE
Use only the cable supplied with the appliance.
Insert the power supply cable into the plug at the side of the appliance.
Insert the plug into the power supply socket: the red pilot lamp will light up to
show that the heating place is on. After few minutes, the green pilot lamp will
light up to show that the heat-accumulation phase has been completed.
During charging, the appliance must be placed flat.
Please pay attention to the appliance during the charging time.
Now remove the power cable and take heating plate to the table, holding it
firmly by the handles.
The item keeps the servings warm for approximately 2 hours. It is however
possible to charge it again after the first hour in order to carry out a new
cycle of heating.
For best results, we urge you to pre-heat the serving dish before placing the
serving dishes on it.
Remember that the heating plate is not designed for carrying disches or
trays: first take the heating plate to the table and then take the serving dish,
which you can then place on the stainless stell plate.

CLEANING AND MAINTENANCE

This appliance does not require special maintenance.
It is enough to check periodically if cuts or wearing signs appear on the
cable.
Disconnect the appliance before carrying out cleaning and make sure that
the plate has been completely cooled off.
Use a slightly damp cloth to clean the appliance.
Never use abrasive products or chemical solvents.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.