Advertisement
Available languages
Available languages
Installation
The parabolic antenna is already pre-assembled and
comprises only two parts:
– the complete spine section with mast fixing
bracket and feed arm that folds out, and
– the reflector.
When installing, observe the earthing and
safety regulations in EN 50 083, Part 1
Fitting the spine section to the mast
•
Take the spine
section out of
the packaging
and fold out the
mast fixing
bracket.
•
Fit the spine
section to an
antenna mast,
free-standing
mount or wall
bracket. The
antenna mast,
free-standing
mount or wall
bracket must be of
a size appropriate
for the size of the
antenna, and be
vertical.
•
Remove
the transport clip on
the feed arm, fold
out the feed arm
and fix in position
by tightening the
hexagon socket
head bolt at the
base of the spine
section.
6
•
Adjust the
spine section
using the elevation
scale and tighten
provisionally using
the wing nuts.
Final tightening is
performed after
the parabolic
antenna has been
aligned.
Fitting the receiving system
•
Fit the receiving
system to the feed
bracket. Keep the
mounting bracket
down while un-
screwing - then
the plastic ring
moves down a
little (otherwise the
screw may cant to
the winding in
case of refixing).
Lay the cable in
the feed arm and
spine section. Adjust the length of the cable, fit
an F-type plug and connect.
Fitting the reflector
•
Slide on the reflec-
tor with the reces-
ses over the four
hexagon socket
head bolts towards
the spine section
and bolt in place.
Pull the reflector
after assembling
and during the
fixing downwards
onto stop position.
•
Tighten the
reflector screws
with 7-8 Nm.
Advertisement
