ECG 20 H01T2S2 Instruction Manual page 129

Parameters for switching polarizations and LNC bands or for switching multiple LNCs among each other are
set in the table on the right�
When you press the button GUIDE you call up the list of transponders of the selected satellite where you can
select, add, delete and edit� A transponder overview is displayed in the table on the left, and on the right you
can set parameters to switch polarizations and LNC bands or to switch multiple LNCs among each other�
You can add transponders by pressing the yellow button Add and delete transponders by pressing the red
button delete � If you mark one or more transponders by pressing OK, you can start their auto-tuning by
pressing the blue button Scan� The signal quality of the selected transponder is displayed on the scale in the
middle�
You can edit frequency, symbol speed and polarization of the selected transponder when you press the green
button Edit � Save the changes by pressing rhe button OK�
Setting satellite
Transponder
Quality
TransPonder OK Select
Exit Delete
Setting satellite
Transp
Edit
Transponder
Frequency
Symbol (pc/s)
Polarity V
Quality
End OK Confirm
Ku HOTBIRD 6,7,A,8
Type LNB 09750/10600
LNB power 13/18V
22 kHz Auto
Toneburst None
DiSEqC1�0 LNB2
DiSEqC1�1 None
Motor None
Edit
Scan
Add
09750/10600
013
13/18V
121�63
Auto
27500
Nothing
LNB2
Nothing
Motor None
GB
129