Backlight Control - Aardwolf RAINBOW EDITION User Manual

English

Backlight control

- Button (1) - turn on the backlight;
- Button (3) - turn off the backlight. Automatic saving of settings after shutdown;
- Button (2) - turn on the automatic reproduction of light effects;
In the off state, press this button to enter the setup menu, then press the (5) M + or (8)
M- button to adjust the LED pixels. Blue button is to adjust the sequence of RGB. After
finishing the settings, press the button (3) to save and exit.
- Button (1) - continue playback;
- Buttons (6) or (9) - increase or decrease the backlight brightness;
- Buttons (4) and (7) - speed adjustment;
- Buttons (5) or (8), - switching current lighting effects;
- Colored buttons - switch the monochrome backlight, the color of the button corresponds
to the color of the LED ribbon backlight;
- Button (10) - the function of adjusting the RGB sequence in the off state.
You must press the (2) AUTO button to enter the setup menu. The first three LED bars
will display the current RGB glow sequence. Press the button (10) to adjust the RGB
sequence until the red, green, and blue sequence is established. Then press the button
(3) OFF to save the settings.
To make the fan constant light - click on one of the 12 colors, shown in the bottom panel.
The current visual effects settings remain unchanged after the computer is turned off
and on again.
The red indicator (on the remote on top) - lights up each time you press any of the
buttons (confirms the operation of the buttons / transmission of the command over the
radio channel).
If the indicator does not light up or the controller does not respond to the commands
from the remote control, replace the battery in the remote control with the one indicated
in the specification, according to the information on the remote control.
Сontroller connection with remote control
- Button (11) - press and hold the button for 5 seconds - the remote control is tied to the fan
controller. The controller is controlled only from this remote control. The function is available
only for the radio version of the console.
- Button (12) - press and hold the button for 5 seconds - the remote control is decoupled from
the controller. The controller responds to signals from any suitable remote. The function is
available only for the radio version of the console.
WWW.PERFORMA.COOL
7