IMPORTANT SAFETY INSTRUCTIONS 1. Read instructions - All the safety and operating instructions should be read NOTE TO CATV SYSTEM INSTALLER before the product is operated. This reminder is provided to call the CATV system installer’s attention to Section 2. Retain instructions - The safety and operating instructions should be retained 820-40 of the NEC which provides guidelines for proper grounding and, in particular, for future reference.
Page 3
CAUTION governmental regulations or environmental public instruction’s rules that • Changes or modifications to this equipment not expressly approved by NAD apply in your country or area. Electronics for compliance could void the user’s authority to operate this 24. Safety Check - Upon completion of any service or repairs to this product, ask equipment.
GETTING STARTED TABLKE OF CONTENT IMPORTANT SAFETY INSTRUCTIONS ........2 GETTING STARTED .
Page 5
Quick install Guide Start up To do initial setup of NAD Amp1 and connect to a network, follow the points 1-7 below. Notice: the NAD Amp1 has built in Wi-Fi but NAD Amp1 also has LAN connection. We recommend using the LAN connection, if possible, for optimal signal and signal stability.
Getting started UNPACK and INSTALL WHAT'S IN THE BOX..• NAD AMP1 • Quick start guide • Power cable • Remote Control with AAA batteries • Google Chromecast instructions We recommend that you keep the original box and packing material for future. transportation.
IDENTIFICATION OF CONTROLS FRONT CONTROLS ③ ④ ① ② Power On power Off - Press to power ON, press to power OFF. Remote eye sensor Five LED Input indicators - from left to right: Cast/BT, Phono, Line In, Optical Input (D1), Optical Input (D2) Volume control and selector.
- Connection for turntable grounding. 2. Streaming - For LAN cabled Internet access. The NAD Amp1 has built in Wi-Fi but NAD Amp1 also has LAN connection. We recommend using the LAN connection, if possible, for optimal signal and signal stability. 3. Phono - Only Connect a turntable to this input, remember to connect “GND”...
REMOTE CONTROL OF THE AMP1 AMP 1 REMOTE CONTROL UNIT 1. Power ON/OFF - Press to turn power On or Off. ① ⑤ 2. Input selector - Press to choose your desired input source. D1 for TV audio and D2 for Hi-Fi is digital/optical input 1 and 2. “Wave”...
IR learn so you can force the television to broadcast IR commands to your product, thus using your TV remote control to control your NAD Amp1. Find it in the list under setup on your TV to use this feature. Check the manual for your TV if in doubt.
50kHz by a second order filter, such as used in Neumann cutting lathes. NAD SHALL NOT BE HELD LIABLE FOR ANY TECHNICAL OR USER INTERFACE DISCREPANCIES IN THIS MANUAL. THE AMP1 OWNER’S MANUAL MAY BE SUBJECT TO CHANGE WITHOUT NOTICE. CHECK OUT WWW.NADELECTRONICS.COM FOR THE LATEST VERSION OF THE AMP1...
Page 12
All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.