Specifications - NAD AMP 1 Owner's Manual

SPECIFICATIONS

All specs are measured according to IHF 202 CEA 490-AR-2008 standard. THD is measured using AP AUX 0025 passive filter and AES 17 active filter.
GENERAL SPECIFICATIONS
LIJNINGANG/LUIDSPREKER UIT
Continu outputpower @ 4 Ohm and 8 Ohm
IHF dynamic power
THD (20 Hz – 20 kHz)
Frequencyrespons
Signal/Noise ratio
Input impedance (40 watt bij 8 O hm)
Max. input signal level
Ingput sensitivity PHONO*
Supported bitsrate/sample-frequency
INPUTS/CONNECTIONS
2x Optical Digital S/PDIF (Toshlink)
1x Analog stereo input (RCA)
1x Phono MM (Moving Magnet)
1x LAN Network connector
POWERCONSUMPTION
Standby-powerconsumption >0.5Watt, Network Standy
<3 watt
2 x 40 W (ref. 20 Hz-20 kHz THD 0,03%, both channel driven)
@ 8 Ohm: 50 W
@ 4 Ohm: 100 W
<0,03 % (+/- 3dB 20 -20.000 Hz)
3 - 60.000Hz
>106 dB (A-Weight, Optical input, ref. 40 watt @ 8 Ohm) Line
in: 450mV Digital in: -5dB FS
>2.1V (ref. 0.1% THD)
5mV (ref.40watt 1Khz 8 Ohm @ max. volume)
24-bit/192kHz via Optical Input
Bluetooth receiver
WiFi WLAN 2.4 Ghz
DIMENSIONS AND WEIGHT
Gross dimensions W x H x D
Net weight
*: ±0,3 dB (20 Hz - 20 kHz)
Note: The RIAA response is consistent with a pre-emphasis that is
rolled off at 50kHz by a second order filter, such as used in Neumann
cutting lathes.
NAD SHALL NOT BE HELD LIABLE FOR ANY TECHNICAL OR USER
INTERFACE DISCREPANCIES IN THIS MANUAL. THE AMP1 OWNER'S
MANUAL MAY BE SUBJECT TO CHANGE WITHOUT NOTICE. CHECK OUT
WWW.NADELECTRONICS.COM FOR THE LATEST VERSION OF THE AMP1
OWNER'S MANUAL.
220 x 63 x 252 mm
4,85 kg (10,7 lb)
11