Operation - InVento 500094 Manual

Charging socket
Charging by the remote controller
Open the charger cover on the remote controller and take out the charging cable. Insert the charging plug into the charging
socket on the vehicle.
Charging by the USB cable
Insert the USB plug into the USB port on your computer. The charging LED lights up. Insert the charging plug into the charging
socket on the vehicle. The charging LED will extinguish to indicate the charging is in process. The LED will light up again after
approximately 1 hour to indicate the vehicle has been completely charged.

Operation

1. Move the ON/OFF switch on the vehicle and on the controller to ON. The LED on the controller will light up.
2. The trimmer is used to adjust the vehicle´s straight-line stability.
3. The remote controller has 5 gears. Press the left gearshift to shift up (speed: 0 – 30 km/h). Press the right gearshift to shift
down and reduce speed.
Trimmer
ON/OFF
switch
Charging plug
Power LED
Left gearshift (shift up)
Forward/back-
ward button
5 gear mode (red LED off)
Standard mode (red LED on)
6
Antenna
Charging LED
Right gearshift (shift down)
Turn left/right
button
ON/OFF switch
Backwards fine tuning
Forwards fine tuning