REMEHA iBase RF-Base station User Manual page 31

Fault indication
Problem
Solution
Fault indication
Problem
Solution
Fault indication
Problem
Solution
tabel 02 Fault indications green status LED
= ½ sec. on.
= ½ sec. off.
T001500-B
Green status LED flashes as follows:
No connection with iSense RF.
- Check whether the iSense RF indicates a fault or is on.
- Try to re-establish the connection between the iSense RF and
the Base station; see Chapter 5.
- If this does not solve the problem, relocate the iSense RF or the
Base station or remove obstacles that can interfere with the RF
signal; see paragraph 3.1.
Green LED flashes as follows:
Power problem
Check whether the boiler is on and whether the Base station is
correctly connected. If the boiler does not support OpenTherm Smart
Power, then connect an external (5 V DC 300mA) adapter.
Green LED flashes as follows:
There is no OpenTherm communication for 60 seconds.
- Check whether the boiler is on and whether the Base station is
correctly connected.
T001500-B T001500-B
T001501-B
EN
T001502-B
T001503-B
31