Autostart Port; Ethernet Ports - gefran GF_VEDO TL Series Installation And Operation Manual

3.6.2 Autostart Port

GF_VEDO TL uses the optional Autostart output to activate an external relay by means of a programmable internal
timer. Activation requires that only the relay be powered, and to run the external devices you have to use the free
contact of the relay (activation time approx. 10 seconds).
We recommend the use of 24VDC relays with a maximum of 100mA at the coil.

3.6.3 Ethernet ports

GF_VEDO TL uses Ethernet ports to dialog via IEEE 802.3 Ethernet protocol. Each Ethernet port can dialog at
10/100 Mbps using an 8-pin RJ45 connector with LED.
We recommend an Ethernet Base-T with braided leads (CAT. 6). The wiring scheme must conform to standard
TIA/EIA-T568-A. Signal assignment is shown in Table 6.
1
Fig. 16
GF_VEDO TL Ethernet port connector
80543B_MHW_GF_VEDO-TL_0109_ENG
+24Vdc
100mA max
Fig. 15 - Connection of external relay to Autostart port of GF_VEDO terminals
8
5 3 1
6 4 2
GND
Pin Name
1 TX_D+
2 TX_D-
3 RX_D+
4 N.C.
5 N.C.
6 RX_D-
7 N.C.
8 N.C.
LED green left
LED yellow right
Signal assignment for GF_VEDO TL Ethernet port
Description
Tranceive data +
Tranceive data -
Receive data +
Not connected
Not connected
Receive data -
Not connected
Not connected
Link
Data
Table 6
15