Installation; Water Supply Connections - Zanussi DA 4342 Instruction Book

Installation

Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
Any plumbing work required to install this
appliance should be carried out by a qualified
plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a
drain.
Levelling
Good levelling is essential for correct closure and sealing of
the door. When the appliance is correctly levelled, the door
will not catch on the levelling spacers on either side of the
cabinet. If the door does not close correctly, loosen or
tighten the adjustable feet until the machine is perfectly
level.

Water supply connections

This dishwasher must be plumbed into a cold water supply.
Do not use, for the connection, old hoses which have been
used in former times.
The water pressure must be within the limits given in the
"Technical specifications" (Instruction Book - part 2).
Your local Water Authority will advise you on the average
mains pressure in your area.
The dishwasher features fill and drain hoses which can be
turned either to the left or the right to suit the installation.
Do not use, for connection, old hoses which have been used
in another appliance.
The locknut must be correctly fitted to avoid water
leaks.
Avoid bends or kinks in the hose which could prevent or
slow down the water supply.
If the machine is connected to new pipes or pipes which
have not been used for a long time, you should run the
water for a few minutes before connecting the inlet hose.
This will prevent deposits of sand or rust clogging the inlet
hose.
All manuals and user guides at all-guides.com
12
IN11
IN12