Page 1
Model No. QUATTRO500 (MANUAL) Model No. QUATTRO600 (AUTO) REMOTE CARAVAN MOVER Electronics installation guide, user information and troubleshooting Ref: QUATTRO500-ELECTRONICS-UM...
Page 3
Before First Use - Single Axle and Twin Axle Modes Page 5 Before First Use - Pairing the Handset and Control Unit(s) Page 5 Using Your Caravan Mover with Quattro Technology Page 5 Operation - Getting Started Page 6 Troubleshooting Page 6/7 Package Contents (Fig.A)
‘A’ frame. Please refer to Table.B (below) for fitment of the motor units to the REAR of the axle. Note: If you are fitting two sets of motors onto a twin-axle caravan to form a full Quattro system then both Table A & Table B wiring will be utilised.
Install the Isolation Switch (29) between the battery and the Control Unit on the positive (+) cable, use two of the 8mm Battery Terminal Connectors (22) to link the cable to the switch terminals. Nuts and bolts are provided to mount the switch but please substitute as necessary if they are not of a suitable type.
Page 6
Control units supplied. It is possible to upgrade in the future from a 2 motor system to a 4 motor system by simply purchasing a second Quattro mover system. Note you will need to pair your existing handset to the second control box, and will need to change to the AWD mode in your handset settings.
Page 7
Operation - Manouvering The Quattro mover utilises a thumb stick for precise control over speed and direction. The speed of operation is dictated by how far the stick moves from its centre point, to the outer point. Direction is dictated by the radial position of the thumbstick (moving the stick from left to right).
Page 8
(Fig.5). Operation - Shutdown procedure Turn off isolation key to cut power to the Quattro control box. To turn off the handset hold the multifunctional button (Fig.1C) for 2 seconds to enter the system menu.
Settings - Handset pairing and operational mode changes The Quattro handset has a settings menu which allows the user to pair their handset or change operating modes. With the handset powered on and at the home screen, hold the multi-function button (Fig.1C) for two seconds and then move the thumb stick downwards to move through the menu items.
Need help?
Do you have a question about the 600 and is the answer not in the manual?
Questions and answers