JVC HR-S6975EK Instructions Manual page 25

set pdc mode Press
PDC
Programme Delivery Control (
recording still works in the event of a change in time of broadcast. If you set
to , your VCR will be turned on not by its own timer but by a signal
ON
transmitted by the broadcaster. This means that if an advertised programme is
delayed, your VCR will still record it properly.
satellite receiver users To timer-record a satellite broadcast using Express
Timer Programming:
• You cannot set
PDC
• You cannot timer-record the satellite broadcast received on the channel
position '0' by the satellite receiver.
• Leave the satellite receiver's power on.
For memory capacity and Serial Recording, see
on page 22.
Return to Normal Screen
Press PROG or OK button.
about 5 seconds, then the normal TV screen appears.
Engage Timer Mode
You must now put the VCR into Timer Mode by pressing c otherwise no
recording will take place. c will appear on the display panel. To disengage the
Timer Mode, press c again.
If a video tape with the safety tab removed is loaded, c, Play indicator (,) and
Record indicator (U) will flash. Insert another tape with the safety tab in place to
record!
If no video tape is loaded, c indicator will flash. Insert a tape to record!
If the tape reaches its end during timer recording, the recording stops and "c",
"U" and "," on the display panel blink. Press c to disengage timer, then press
S/0 on the VCR or
press < to rewind the tape.
(number key ) to change between
7
PDC ) is a service designed to ensure that timer
to .
ON
PROGRAM COMPLETED
on the Remote Control to eject the tape or press othen
basic features
and
ON
VIDEO Plus+ Timer Programming
appears on the TV screen for
25
.
OFF
PDC