Advertisement
The Eastwood 2 Ton Aluminum Double-Piston Hydraulic Floor Jack raises the vehicle quickly, and
with a 3-1/2" minimum saddle height, it gets under low-profile vehicles without a problem. It's made
of strong, lightweight, aluminum for easy maneuvering around your garage. Meets ANSI specs.
SPECIFICATIONS
LIFTING CAPACITY
MIN. SADDLE HEIGHT
MAX. LIFT HEIGHT
HANDLE LENGTH
SAFETY INFORMATION
READ INSTRUCTIONS!
SAFETY WARNINGS
2
2 Tons (4000 lbs.)
3-1/2"
18-3/8"
47-3/4"
• Read this entire manual before set up and use.
• Keep this manual in a safe location as it will be necessary to refer to it often.
• Always wear ANSI-rated eye and hand protection when using this jack.
• Keep children away from work area.
• Pinch Hazard. Keep hands and feet away from moving parts when operating.
• Do not exceed the load rating of the jack (2 Ton, 4,000 lbs.)
• This jack is for lifting purposes only! Use proper jack stands for sustaining
any load. Before going under any lifted object support the load with stands
suitable for the weight.
• Only use this jack on level, flat, hard surfaces.
• Purge air from the hydraulic pump prior to first use and any time necessary
during the life of the jack.
• The operator and any bystanders of the jack should be trained and use care
while operating.
• Improperly secured loads, overloading, and off-center loads may all lead
to failing, slipping, falling, etc. of the object being supported. It is up to the
operator to properly load the jack.
• Do not use this jack for a task it was not designed for.
• Before each use the operator should inspect the jack for any abnormal
conditions including broken, damaged or missing parts as well as leaks.
• Do not move the vehicle or other load while on the jack.
• Lift vehicles only in areas that are specified by the manufacturer of the vehicle.
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
LENGTH
25"
WIDTH
12-1/2"
WEIGHT
45 lbs.
Advertisement
