Vent-Axia 427585 Instructions Manual

Mobile Air Conditioner
Please read these instructions carefully before
IMPORTANT
♦ Ensure that the Voltage marked on the unit agrees with your mains Voltage.
♦ The unit installation must comply with all applicable local and national regulations.
♦ The Air Conditioner is a Class 1 appliance and MUST BE EARTHED.
♦ The manufacturer does not accept any liability if the safety standards are not observed.
♦ This unit complies with all applicable EC Directives.
♦ The wires in the mains lead are coloured in accordance with the following code:-
GREEN/YELLOW = Earth
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug proceed as follows:
♦ The wire, which is coloured green/yellow, must be connected to the terminal in the plug, which is
marked with the letter E, or by the earth symbol or coloured green or green/yellow.
♦ The wire, which is coloured blue, must be connected to the terminal, which is marked with the letter
N or coloured black.
♦ The wire, which is coloured brown, must be connected to the terminal, which is marked with the
letter L or coloured red.
The above cooling capacity stated in the table above was measured at a room temperature of 30°C,
relative humidity 70%
Specifications are subject to change without notice for further improvement.

operating this unit

BLUE = Neutral

SPECIFICATIONS

BROWN = Live