Advertisement
2. Reset options and status LEDs
In case of any problems, the xxter device can be reset in several
different ways, see also image 11:
BUT1 Hold during boot
BUT1 Press shortly
BUT1 Press long (longer then 3 sec.)
BUT2 Press shortly
When the xxter device is connected to power, the system status can be
seen using the LED indicators:
LED1
green slow flashing
LED1
green continuous
LED2
green slow flashing
LED2
yellow slow flashing
LED2
red quick flashing
LED2
red / green intermittent
*) the Internet connection is only verified during boot and when the "Check Internet connection"
button is pressed on the status page of the xxter device.
Image 3: xxter rear panel
Reset to factory defaults
Full restart
Reset to factory defaults
Reset application (soft restart)
Currently booting or shutting down
Application started and ready for use
Normal operation - OK
No connection to KNX or enOcean
LAN problem, no network
No Internet connection, only LAN connection*
HK01x manual
5
Advertisement
