Advertisement
enOcean
In case you are using a xxter model with enOcean support (HE01,
HCE01 of HKE01), then the enOcean antenna has to be connected to
the serial port (RS232) on the front side of the device (see Image 7).
1) Make sure the power adaptor of xxter is not connected.
2) Connect the serial connector of the ANE01 to the serial port
(RS232) of the xxter unit.
3) Connect the electrical splitter cable to the xxter unit.
4) Connect the power adaptor to the electrical splitter cable.
Image 2: enOcean connection schema
The enOcean ANE01 antenna is equipped with a repeater function.
The ANE01 repeater has three different settings:
1) No repetition (standard): both dip-switches to OFF (numbered
side)
2) Repeat only original telegrams (level 1): set only dip-switch 1
to ON
3) Repeat both original and one time repeated telegrams: set both
dip-switches to ON
Before a new repeater setting is active, it is required to shortly
disconnect the ANE01 from the power source.
4
HK01x manual
Advertisement
