Summary of Contents for xxter HK01 Series
- Page 1 HK01x manual Version 1.0 – July 2019 © 2015 xxter bv. All rights reserved. More information can be found at www.xxter.com...
- Page 2 Contents 1. Connecting the device 2. Reset options and status LEDs Technical specifications Welcome With xxter you can extend an automated home or office in only a few steps and control it with a smartphone or tablet. This manual describes the connections and LED indicators of the first generation xxter device, like the HK01E. For more information about the working and configuration options of xxter an installation manual and a user manual is available. Please refer to www.xxter.com for more information. HK01x manual...
- Page 3 1. Connecting the device The steps to connect the xxter device depend on the model that is used. For all models the UTP cable has to be connected to the (internal) network. xxter has to be able to connect to the Internet, to download the configuration and for future firmware updates. KNX direct In case you are using an xxter model with a direct KNX-bus connection (HK01 of HKE01), then connect the bus cable to pin 2 (KNX min/black) and pin 3 (KNX plus/red), see image 6. First connect xxter to the KNX- bus and then connect xxter’s power adaptor to the power socket. Image 1: xxter rear panel KNX connection over IP When using KNX over a KNXnet/IP module, please make sure the xxter unit and the KNXnet/IP module are both connected to the same internal network. Artnet DMX For the use of DMX components, an ArtNet->DMX node is required. This node must also be connected to the same internal network as the xxter unit. A list of ArtNet->DMX nodes that are tested with xxter can be found on the website. Philips Hue When using Philips Hue, make sure that the xxter unit and the Hue network module (bridge) are both connected to the same internal network. HK01x manual...
- Page 4 In case you are using a xxter model with enOcean support (HE01, HCE01 of HKE01), then the enOcean antenna has to be connected to the serial port (RS232) on the front side of the device (see Image 7). 1) Make sure the power adaptor of xxter is not connected. 2) Connect the serial connector of the ANE01 to the serial port (RS232) of the xxter unit. 3) Connect the electrical splitter cable to the xxter unit. 4) Connect the power adaptor to the electrical splitter cable. Image 2: enOcean connection schema The enOcean ANE01 antenna is equipped with a repeater function. The ANE01 repeater has three different settings: 1) No repetition (standard): both dip-switches to OFF (numbered side) 2) Repeat only original telegrams (level 1): set only dip-switch 1 to ON 3) Repeat both original and one time repeated telegrams: set both dip-switches to ON Before a new repeater setting is active, it is required to shortly disconnect the ANE01 from the power source. HK01x manual...
- Page 5 LAN problem, no network LED2 red / green intermittent No Internet connection, only LAN connection* *) the Internet connection is only verified during boot and when the “Check Internet connection” button is pressed on the status page of the xxter device. Image 3: xxter rear panel HK01x manual...
-
Page 6: Technical Specifications
Technical specifications Size (lxwxh): 180x152x38mm Weight: 0,5 kg Voltage: 5VDC Power consumption: 300mA (avg.) Cooling: passive Accessories: - Adapter 5VDC - UTP cable - enOcean antenna (only for models HE01, HCE01 en HKE01) - Installation manual EN - User manual EN HK01x manual...