Advertisement
2. INTRODUCTION & SPECIFICATIONS
Fast, simple and effective way to sharpen your drill bits. Gives a perfect angle/sharpened head to make drilling with your bit easier. Suitable for
use with HSS, titanium, cobalt and carbon steel ranging 3mm to 13mm.
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .SMS2008
Motor Power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80W-230V
Free Speed: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4200rpm
Minimum Drill Diameter: . . . . . . . . . . . . . . . . . . . . . . . . . . Ø3mm
Maximum Drill Diameter: . . . . . . . . . . . . . . . . . . . . . . . . . Ø13mm
3.
OPERATION
3.1.
Setting
3.1.1. Remove the drill bit holder from its location.
3.1.2. Loosen the locking ring (fig.1) and insert the drill bit; tighten the locking ring lightly.
3.1.3. Lock the drill bit holder into the setting location whilst holding the setting lever (which controls the spring jaws) open, allowing the drill bit
to be pushed back by the terminal (see fig.2). Ensure that the drill bit is inserted with the flutes at the tip horizontally aligned, as in fig.2.
3.1.4. Tighten the locking ring fully before removing the drill bit holder from the setting location.
3.2.
Sharpening
3.2.1. The settings achieved in section 3.1. are transferred to the sharpener by moving the drill bit holder, complete with drill bit, to the
sharpening location.
3.2.2. Switch the machine on by means of the on/off switch.
3.2.3. Insert the drill bit holder into the sharpening location ensuring that the upper lugs on the holder body are engaged with the cut-outs in
the collar (fig.3).
3.2.4. Sharpen the drill bit by rocking the collar back and forth until the sound from the wheel diminishes.
3.2.5. Remove the drill bit holder, rotate through 180° and repeat step 3.2.4.
3.2.6. If an arrow head point has not been achieved, turn the drill bit through 90° in the holder and repeat from 3.1.2.
© Jack Sealey Ltd
fig.2
fig.1
fig.3
Original Language Version
SMS2008
Issue:2(I) - 21/10/14
Advertisement
