Using The Camera; Low Battery Indicator; Using The Controller - Techalogic DC-1 User Manual

Using the Camera

Hold down the main button for a few seconds to turn the camera on, it will vibrate once.
1.
When the camera is turned on the white recording LED will illuminate, it will automatically enter recording
2.
mode after approx. 8 seconds and will start to flash.
The blue Wi-Fi indicator light will flash and enter pairing mode. If the camera is not connected to your mobile
device within 1 minute, it will automatically switch off.
To activate the Wi-Fi again quick short press the Main button twice.
3. To connect with your mobile device go to your device settings and switch on the Wi-Fi and locates the
Techalogic DC-1 device. Once located, tap to open. The password is 12345678. Once the device successfully
connected now open the APP (once downloaded to phone, refer to Techalogic QR Code/User Manual Code
for APP download options) and press the blue 'Camera' bar to view front and rear images.
Note. If you keep the Wi-Fi on before switching off the camera, it will come on automatically the next time you turn on
the camera.
4. Hold down the main button for a few seconds to turn off the camera. It will then vibrate twice and turn off.
5. If the camera detects no memory card or a card reading error, it will alert you by vibrating three times.

Low Battery Indicator

•
The green battery light shows the camera battery status.
•
Green light steady: battery power is at least 50%.
•
Green light slowly flashing: battery power is 30–50%.
•
Green light quickly flashing: battery power is less than 30%.
Intelligent energy-saving system
1. In standard recording mode if the camera stays static for 3 minutes it will automatically turn off to save power.
2. When an external power supply is used, the energy-saving system will not work.

Using the Controller

1. The remote is fully wireless allowing for flexibility of use.
2. The camera and remote will automatically connect within 3-meter range.
4