Transaxle Service - Graco LineDriver ES Series Operation - Repair - Parts

Transaxle Service

Check Oil Level (Annually)
1. Turn power OFF. Engage Manual Brake.
2. Slowly raise hitch coupler until LineDriver rests on
rear bumper.
3. Remove fill plug from transaxle cover.
4. Slowly lower hitch coupler. Oil will begin to flow out
of transaxle when hitch coupler is lowered to 10.5 -
12.5" from the floor. Add or remove oil as needed.
3A6623C
5. Reinstall plug.
Change Oil (recommended every 3 years)
1. Turn power OFF. Engage Manual Brake.
2. Slowly raise hitch coupler until LineDriver rests on
rear bumper.
3. Place pan under transaxle cover. Remove screws
and cover.
NOTE: Sealant may hold cover on. If necessary, pry
cover off.
4. Allow oil to drain completey. Follow local ordinances
and regulations for disposal.
5. Clean cover and housing where sealant is used.
Apply new sealant (recommended is RTV silicone).
6. Reinstall cover with screws.
7. Remove drain plug. Fill with 22 oz. of Mobilfluid™
424.
8. Check oil level per above. Reinstall plug.
9. Check for oil leaks. Fix if necessary.
Maintenance
15