Table of Contents
Advertisement
How to Use the Speaker and Amplifier
The audio stand incorporates a built-in amplifier and speaker, a 3.5mm audio
jack, a stereo input cable, and a "holder" that will hold many popular portable
audio players.
1. Plug the power cord that extends from below the stand into a
120V AC outlet.
2. Turn on the amplifier speaker by "rocking" the power-on switch which is
located under the stand. (See fig 5).
3. Power light underneath the "holder" will show when system is turned on.
4. Plug stereo input cable into the audio jack.
5. Plug the stereo input cable into portable audio player.
6. Turn on audio player, starting with the volume low and then adjust to
desired level.
7. Place player into holder.
Servicing Instruction:
Caution: "These servicing instructions are for use by qualified service personnel
only. To reduce the risk of electric shock do not perform any servicing other than
that contained in the operating instructions unless you are qualified to do so"
* The specification of slow blow type current fuse:
Manufacture: Walter Electronic Co., Ltd
Type: BTP
Rating: 1A, 250V
SPEAKER SPECIFICATIONS:
1. POWER On/Off: Yes
2. Frequency Level: 55~18 KHz
3. Power Supply: AC
Fig. 5
Audio jack
Power switch
10
iPOD® MP3 Holder
iPOD® MP3 Holder
Power Light
Advertisement
Table of Contents
