Toro TimeCutter 74726 Operator's Manual page 15

Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction
Park Position
Move the motion-control levers outward from the
center to the P position when exiting the machine
ARK
(Figure 24). Always position the motion-control levers
into the P position when you stop the machine or
ARK
leave it unattended.
Smart Speed™ Control System
Lever
The Smart Speed™ Control-System lever, located
below the operating position, gives you a choice to
drive the machine at 3 speed ranges— trim, tow, and
mow (Figure 27).
Fuel-Presence Window
You can use the fuel window, located on the left side
of the machine, to verify the presence of fuel in the
tank (Figure 7).
1. Fuel-presence window
(Figure
Figure 7
Height-of-Cut Lever
Use the height-of-cut lever to lower and raise the deck
5). from the seated position. Moving the lever up (toward
you) raises the deck from the ground and moving the
lever down (away from you) lowers the deck toward
the ground. Adjust the height-of-cut only while the
machine is not moving
Hour Meter (If Equipped)
The hour meter records the number of hours when
you are in the seat and the key switch is in the O
position (Figure
1. The hour meter is located behind the seat.
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
g014521
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
15
(Figure 29).
8).
Figure 8
N
g027869