Advertisement
1
Elevator Shaft
Base
B
C
Tabs
A
Bottom Slots
Elevator Shaft Ledge
• Position the elevator shaft on a flat surface.Note the
locations of the bottom slots, snap slot and retainer on
the elevator shaft.
• While holding the base at an angle, fit the locator tabs
into the bottom slots in the elevator shaft A.
• While making sure the base lip fits over the elevator
shaft ledge B, insert and snap the hooked tab on the
base into the slot in the elevator shaft C.
• Insert and snap the tab on the side of the base ramp
into the retainer in the elevator shaft D.
Assembly
A
Base
B
Lip
C
Retainer
D
D
2
Top
Floor
Columns
Groove
Groove
Base
• Insert and snap all five top floor columns into the
grooves in the base. Make sure the top floor lip fits
over the elevator shaft ledge.
3
Top Floor Lip
Elevator
Shaft
Ledge
Grooves
Advertisement
