Spaulding Lighting RDIC Series Installation Instructions

Led compact wall sconce

Advertisement

Available languages

Available languages

Installation INSTRUCTIONS - LED COMPACT WALL SCONCE
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes.
Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and
use so fixture failures do not cause a hazard and use only in environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION! Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding
luminaire operation and burning position. Luminaire label shows electrical and environmental requirements and
restrictions.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED
Turn off electric power to all affected circuits and allow to cool before servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat
retention. Dusting with a soft, clean, dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt
should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any
work, contact your Hubbell Lighting distributor or techsupport@hubbell-ltg.com or (864) 678-1000
Give instructions to facility owner/manager for future reference.
NOTE:
This luminare is designed for outdoor lighting applications with ambient tempertures not exceeding 40° C

WARNINGS:

Dangerous voltage exist within the unit and all precautions usually observed in handling high voltage equipment should be observed
when replacing light engine or otherwise servicing luminares. Disregarding this warning could result in electrical shock and possible
injury to the individual installing or servicing this equipment. Installation and servicing should be done by qualified personnel.
93052313 Rev.A
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
SAVE THESE INSTRUCTIONS
INSTALLATION
INSTRUCTIONS
Compact Wall Sconce
Series-TRPC, RDIC,
QSPC
READ THOROUGHLY BEFORE INSTALATION
http://www.spauldinglighting.com
SHEET 1 OF 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RDIC Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Spaulding Lighting RDIC Series

  • Page 1 INSTALLATION INSTRUCTIONS - LED COMPACT WALL SCONCE SHEET 1 OF 3 SAVE THESE INSTRUCTIONS INSTALLATION INSTRUCTIONS Compact Wall Sconce Series-TRPC, RDIC, QSPC READ THOROUGHLY BEFORE INSTALATION WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH.
  • Page 2 INSTRUCTIONS D'INSTALLATION D'APPAREIL FEUILLE 2 DE 3 SAUVEGARDEZ CES INSTRUCTIONS INSTRUCTIONS D'INSTALLATION TRPC, RDIC, QSPC À LIRE ATTENTIVEMENT AVANT D'INSTALLER AVERTISSEMENT! Les appareils d'éclairages doivent être mis à la terre et installés selon le Code canadien de l'électricité et tous les codes locaux. Ne pas se conformer à ces codes pourrait conduire à DES SECOUSSES ÉLECTRIQUES ET UN DANGER DE MORT OU D'INCENDIE.
  • Page 3 INSTALLATION INSTRUCTIONS - LED COMPACT WALL SCONCE SHEET 3 OF 3 SAVE THESE INSTRUCTIONS Figure 2 Figure 1 IMPORTANT: To weatherproof your outdoor installation, be sure to seal all housing (Mounting, Conduit, Plugs, etc.) with silicone sealant. INSTALLATION: 6.Locate the “THIS END UP” label on the back of the unit as a reference for the following steps. 7.Install the provided self-adhesive gasket to the back of the mounting plate (1).

This manual is also suitable for:

Qspc seriesTrpc series

Table of Contents