Advertisement
Replacing Blades
1. Remove Upper Blade:
a. Remove Upper Socket Screw (13), Spring Washer (5) and Washer (6).
b. Then, remove Upper Blade.
2. Remove Lower Blade:
a. Remove Lower Socket Screw (4), Spring Washer (5) and Washer (6).
b. Then, remove Lower Blade.
3. Installing new or sharpened Blades:
Note: To maintain a consistent cutting edge, install new Blades in sets.
a. Install Upper Blade first and tighten securely.
b. Then, install Lower Blade and tighten enough to allow gap adjustment.
c. Adjust gap according to Gap Adjustment on page 9.
Note: The screw above the Upper Blade is factory-set.
4. Make a few practice cuts on scrap material before cutting your workpiece.
5.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified
service technician.
Upper Socket
Screw
Lower Socket
Screw
(not shown)
1-800-345-4545 jegs.com
12
Advertisement
