kim lighting EL150 Installation Instructions

The Compact Bollard - EL150 Installation Instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
! WARNING: Instructions pertaining to risk of fire or injury to persons. Lighted lamps are hot.
WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code.
!
Failure to take these steps may result in serious personal injury. DO NOT operate luminaire with missing or
damaged lens.
SAFETY WARNING: Fixtures can become very hot depending on the lamp wattage used. Glass lenses and
!
metal areas above and around the lamp can become hot enough to blister hands. Particular care should be
taken not to locate fixtures where children can reach them if higher wattages are used. To maintain light
efficiency and prevent fixture overheating, glass lenses and enclosures must be kept clean and free of dirt, dust,
leaves, trash and mineral deposits from water. Keep away from materials that may burn.
CAUTION: When relamping fixture avoid touching the lamp envelope with bare hands. If touching the lamp is
necessary during installation, clean the envelope with alcohol and dry with a clean, soft cloth before burning.
Contamination of the envelope may reduce lamp performance. All electrical wiring should be done by a qualified
electrician. KEEP THIS SHEET FOR FUTURE REFERENCE. NOT INTENDED FOR INDOOR USE.
NOTE: Keep the lamp free from impact while burning, as this may deform the filament and shorten the lamp life.

Tools Required:

F"Allen Wrench
!
Make certain the electricity is OFF before starting installation.

Base Installation:

1. Install one nut followed by a flat washer onto
each anchor bolt.
2. Place the base casting onto the
anchor bolts.
3. Install flat washers and nuts onto
anchor bolts protruding through
base casting. Level top edge of base casting
by adjusting nuts on bottom. CAUTION:
Concrete footing should be high enough
above grade to avoid contact between fixture
shaft and soil or standing water. Tighten the
upper nuts progressively and evenly keeping
base casting level.
!
Make certain electricity is OFF before starting fixture installation.

Fixture Installation:

1. To protect finish, lay fixture horizontally on soft cloth with open-end of fixture next to installed base casting.
2. Pull fixture wires out from inside riser and make connections to field wires i.e., green-to-ground, white-to-common,
and black-to-voltage.
3. Place fixture over base casting being careful not to pull wires apart.
4. Install four M - 18 x 1" flat head
socket screws into base through
countersunk holes at bottom of
riser. Tighten progressively
and evenly.
Revised 7/16/10 ECN 100715008
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861

IMPORTANT SAFETY INSTRUCTIONS

N" Wrench
M - 18 x 1" Flat
Head Socket
Grade
Conduit
(by others)
Base Installation
Status 7
Narrow Flat Blade Screwdriver
Riser
Screw (4)
Final Installation Detail
Fixture Installation
EL150
Base Casting
Nut and
Washer (3)
Anchor Bolt
(3)
Part No. 95614