kim lighting KLV205 Installation Instructions

Accent Light - KLV205 Installation Instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS
WARNING: To reduce the risk of FIRE, or INJURY TO PERSONS: Do not overdrive fixtures with greater
!
than 12 volts or fixture over-heating and short lamp life will occur. Do not overload the transformer by
installing (or relamping) higher wattage lamps than planned. Note: Total wattage of all lamps connected to one
transformer must not exceed the capacity of that transformer. Do not install luminaire within 10 feet (3.04m) of a
pool, spa, or fountain. DO NOT operate luminaire with missing or damaged lens.
SAFETY WARNING: When relamping, be sure electrical supply is OFF. Low voltage fixtures can become
!
very HOT depending on the lamp wattage used. Glass lenses and metal areas above & around the lamp
can become HOT enough to blister hands. Use discretion when touching fixture and be sure to allow fixture to
cool before relamping. When relamping fixture avoid touching the lamp envelope with bare hands. If touching
the lamp is necessary during installation, clean the envelope with alcohol and dry with a clean, soft cloth before
turning ON. Contamination of the envelope may reduce lamp performance.
MAINTENANCE: To maintain light efficiency and prevent fixture-overheating, glass lenses and enclosure must
be kept clean and free of dirt, dust, leaves, trash (combustible materials) and mineral deposits from water.
Particular care should be taken not to locate fixtures where small children can reach them if higher wattage's are
used.
Note: Keep the lamp free from impact while burning, as this may deform the filament and shorten the lamp life.
N OT INTENDED FOR INDOOR USE. All electrical work should be done by a qualified electrician.
Unit intended for mounting with Diffuser/Glass Barrier and Lamp Holder greater than 2 in. (5.08 cm)
from the ground plane.
KEEP THIS SHEET FOR FUTURE REFERENCE.

Tools Required:

F" Allen Wrench
B" Allen Wrench
Installation Instructions:
1. Remove coupling from fixture.
4. To install lamp, remove four shield
screws.
Revision 10/14/11
EC 111014007
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861

IMPORTANT SAFETY INSTRUCTIONS!

Flat Blade Screwdriver
Philips Screwdriver
!
Make certain the electrical supply is OFF before starting fixture installation.
2. Tighten coupling onto
mounting device.
Shield
Drain Hole
5. Remove shield and lens gasket
assembly.
Status 18
Adjustable Wrench
DO NOT overload the transformer by
installing (or relamping) higher
wattage lamps than planned.
Remember, the total wattage of all
lamps connected to one trans-former
must not exceed the capacity of that
transformer.
3. Install fixture onto coupling. Attach fixture
leads. Note: KIM KLV Mounting Options can
be installed before fixture is attached.
Lens Gasket
Assembly
Screws
6. Install lamp of type and wattage
shown on fixture label and chart on
page 2.
KLV205
IMPORTANT!
Part No. 95489