Preparation For Assembly; Assembly - Silvercrest SEK 2000 A1 Operation And Safety Instructions

Batteries must be kept out of
Q
reach of children. Children
could put batteries in their
mouths and swallow them. If a
battery has been swallowed,
immediate medical attention
must be sought.
Different types of batteries or
Q
rechargeable batteries must
not be mixed.
Always insert batteries with the
Q
correct polarity, otherwise they
might burst.
Remove the batteries from the
Q
appliance if you will not be
using it for a long time.

Preparation for assembly


Remove all packaging materials and transport
locks from the appliance.
Check the items delivered for completeness and
damage.
In order to find a suitable location for wall mounting,
please observe the following information:
1. Mount the appliance at a minimum height of 30
cm with a sufficient distance from the ceiling of a
minimum of 100 cm. To ensure the best possible
heat distribution, however, we recommend a height
of 60 cm.
2. Make sure that the long mounting plate
mounted horizontally on the wall.
3. Observe the dimensions of the product in the
section: "Technical data".
12 GB/IE/NI

Assembly


Note: Read the operating and safety information of
your drill carefully before beginning assembly!
1
To fix the long mounting plate
you need 4 holes at a distance of 110 mm
each. (see Fig. 1)
Drill 4 holes, 8 mm diameter and 26 mm deep to
use the dowels
Place the dowels
cleared them of debris.
Now fasten the long mounting plate
using the screws
2
is only
5
Place the Curved electric built-in fire on the
long mounting plate
plate to the back of the appliance with the long
mounting plate
the metal plate is completely fitted onto the long
mounting plate
to the wall,
5
and screws supplied.
9
10
in the holes once you have
10
to the wall
5
.
9
by connecting the metal
5
(see Fig. 2). Make sure that
5
.
5