JABSCO 60000 Series Manual

WIRELESS REMOTE CONTROL
FEATURES
•
Adds wireless control to existing searchlight installa-
tions for both console and remote control operation.
•
Can be installed for wireless-only operation.
•
12/24 volt operation (60000-0000/60000-0024).
•
True 8-way directional control with instant response for
precise targeting.
•
"On/off" and "spot/flood" selection (for applicable models)
plus LED battery check.
•
Long life lithium battery for hand-held remote control.
•
Meets all applicable regulatory requirements for FCC,
Industry Canada, Australian and European compliance.
•
"First-on" learning mode syncs transmitter and receiver
codes for no cross-talking with other remote control
devices.
•
Up to four wireless remote units can be used per light
•
Power saving "sleep mode" when not in use.

SPECIFICATIONS

Transmitter: 3VDC (CR2032 Battery)
Reverse polarity protected
433.92MHz transmitting frequency
Receiver: 12VDC or 24VDC
10 amp or 5 amp AGC Quick Blow Fuse
Input power short circuit protection
Range: 100 Ft. (30 Meters)
Temperature
Range: (-30° C to 70° C)
Regulatory
Compliance: FCC, Australia, Industry Canada and
Europe (For Radiated Emissions)
Model 60000-0000

INSTALLATION

The Jabsco 60000-0000/0024 Remote adds wireless
control to new or existing Jabsco searchlight installa-
tions. It works in conjunction with a standard hard wired
Jabsco panel mount controller, thereby adding a second
controller for wireless remote operation of the search-
light at a distance of up to 100' (30 Meters). In applica-
tions where a panel mounted controller is not desired,
the 60000-0000/0024 Wireless Remote Control System
can be set up for wireless-only operation.
WARNING
!
Disconnect battery before proceeding. Connecting
cables to the wireless receiver with p ower "on" to
the receiver can damage the unit.
CAUTION
!
!
Do not cut or trim the black receiver antenna wire
(so marked) nor connect it to battery ground (-).
CAUTION
!
!
Do not immerse the hand-held wireless fob in water.
The Jabsco wireless receiver is installed inline between
the searchlight and the hard wired panel controller. (see
Fig. 1, 2). For installations where wireless-only operation
is preferred, the receiver's (female) connector cable is
connected to the searchlight cable. The receiver's (male)
connector cable is not connected in this instance. In
installations where the wireless remote will be used as a
second controller, (in addition to the hard wired panel
controller), the receiver's (male) connector cable is con-
nected directly to the the back of the panel controller or
to the wire pigtail coming from the back of the panel controller.
60000-0024
Full 8-way
Control Pad
On/Off; Spot/Flood
Switching
Grip Strip
LED Signal Transmission
Indicator (Battery Check)
Long Life Lithium Battery