Advertisement
Quick Links
(rev1 June 2016)
Mounting instructions for
ThermalCapture 2.0
Thank you for buying our product. The following instructions will guide you through the
process of mounting ThermalCapture 2.0 to a TAU core. Please read these instructions
carefully before you begin.
Step 1: Remove the VPC Module
If your TAU Core has a VPC-module, please remove it by loosening the marked screws.
The VPC-module and the two screws are not needed in the following process and can be
put away.
Step 2: Remove the back cover
Remove the back cover by loosening the marked screws.The back cover and the four
screws are not needed in the following process and can be put away.
Caution: This will also release the main-board of the Tau core. It will be kept in place only
by its internal wiring. Do not apply strong forces to the main-board at this and the following
step. The internal wiring pulls the main-board down at the upper side of the TAU core, so
that the main-board moves a little bit up at the other side when the screws are released.
Advertisement
Summary of Contents for TeAx Technology ThermalCapture 2.0
- Page 1 Mounting instructions for ThermalCapture 2.0 Thank you for buying our product. The following instructions will guide you through the process of mounting ThermalCapture 2.0 to a TAU core. Please read these instructions carefully before you begin. Step 1: Remove the VPC Module If your TAU Core has a VPC-module, please remove it by loosening the marked screws.
- Page 2 At the end of this step your TAU core should look like this:...
- Page 3 Step 3: Place the circuit board onto the base plate Place the base plate on a flat surface and place the circuit board on it. The rounded edges should be facing away from you, such that the USB plug points to the left side. Step 3a Step 3b Step 4: Apply the back cover...
- Page 4 Tighten the screws carefully. Do not apply strong forces to screws. Step 5a Step 5b Congratulations! You have successfully mounted ThermalCapture 2.0 to your Tau core. Please proceed with the chapters wiring and software configurations from the user guide.