Nice XBA7-XBA8 Instruction And Warnings For The Installer page 6

Attention! – The incorrect positioning of the jumpers may damage the product irre-
versibly.
Attention! – Before removing and moving the jumpers, your body must be free of any
static charge. The body can be protected against charges of static electricity by touching
an earthed metal object (a non painted metal surface).
4 – INSTALLATION
Warnings- Before the installation, perform the checks and operations stated
below:
– Make sure that the surface for the installation is perfectly clean and free of painting
residues; clean adequately when necessary (fig. 6).
– For XBA8 only: if necessary, change the position of the jumpers to set the desired
operation (see paragraph 3).
– For XBA7: should you decide to replace the yellow glass supplied with the product,
see fig. 7. During this operation, take care not to damage the internal electronic board.
To install the product, proceed as described below:
01. Connect up the power cable supplied to the product by inserting the connector in its
seat (fig. 8);
02. Insert the product in the seat prepared inside the lid (fig. 9-a);
03. Fasten the product with the screws supplied (fig. 9-b).
4 - English