Parts List - Whitehall Dickson PB-101 Instructions For Operation And Care Of

the fingertips to the first knuckle and waiting about ten seconds
for the wax to cool. Next, dip the patient's hand from the
fingertips to the second knuckle (proceeding to cover up the first
layer of wax and effectively insulating the hand from some of the
heat). Continue to build the wax up incrementally by small
amounts.
OTHER USEFUL INFORMATION:
l
Model S is an old reference to current models PB-101 and
PB-107
l
Model K is an old reference to current model PB-104
is an old reference to current model PB-105
being manufactured) is referring to an old PB-104 without a
drain.
l
The sanitize mode on the PB-104, PB-105, and PB-107 are
turned on with a timer.
l
The sanitize mode on a PB-101 is turned on with a three- way
switch.
PARTS LIST FOR DICKSON PARAFFIN BATHS
WHITEHALL PART #
1 5902-111-399
2 6902-306-000
3 6902-412-000
4 6902-410-000
5 6902-308-000
6 6902-350-000
7 6902-130-001
8 6902-136-001
9 6902-327-000
10 6902-330-000
11 6902-438-000
12 6902-439-000
13 0710-230-001
WHITEHALL MANUFACTURING • P.O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A Phone (800) 782-
Instructions for Operation and Care of Dickson Paraffin Baths
l
Model BB
l
Model H (no longer
DESCRIPTION
Cover, Stainless Steel
Cover, Plastic
Cover, Plastic
(Front Section)
Cover, Plastic
(Rear Section)
Drain Insert
Drain Valve
Element, Heating 120V
Element, Heating 220V
Element, Heating 120V
Element, Heating 220V
Element, Heating 120V
Element, Heating 220V
Fuse Holder/Cap
7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com
l
All Dickson models have a sanitizing circuit.
l
Standard operating temperature is 126° to 130°F (52.2° to
l
54.4°C) Lowest operating temperature is 126°F or 52.2°C.
Below this temperature, wax will harden (if lid is removed from
the unit or power is off)
l
A capillary thermostat is attached to the temperature control.
This device controls the temperature with a mechanism that
involves a tube filled with oil. The temperature heats up the
oil in the capillary, and the hotter it gets, the higher the oil
rises up the tube.
l
There are 2 overheating sensors in all models except for the
PB-101. The L-145 is the low limit overheating sensor. This
sensor will turn the unit off when it gets in the range of 145°
to 155°F (62.8 to 68.3°C). The other overheating sensor is for
the sanitize mode. This sensor will not allow the unit to go
past 200°F or 93.3°C.
l
Timer is only to be used to turn on the sanitize sequence in
which the temperature of the wax will approach 200°F or
93.3°C. All units except for the PB-101 are simply turned on
by plugging them in. The PB-101 has a switch.
x x
x
x
x
x x
x
x x x
x x
x
x x
x x
x x x
x x x
x x
x
x
x
x x x x x
9