Download Print this page

Using The Keypad - SafeShore HydroSweep Pro Installation And Operating Instructions Manual

Acd (aquatic current device)

Advertisement

When programming, avoid sweeping past dock wheels to prevent excavation of floor under wheels.
Turns unit counter
clockwise
when programming
Off status light
Program status light
Pump motor reset
Initial Startup/Programming of the HydroSweep® Pro ACD:
To program the HydroSweep® Pro ACD:
1- Press the SELECT
2- Press and hold the COUNTER CLOCKWISE
CLOCKWISE
button when it reaches the desired location.
3- Press and hold the CLOCKWISE
button when it reaches the opposing desired location.
4- Press the SELECT
*The HydroSweep® Pro ACD is equipped with a built in circuit breaker for the pump motor, which trips if excessive load is
detected. Debris getting caught in the propeller will trip this breaker. Unplug unit, clean out debris, plug unit back in and reset
circuit breaker.*
*If the unit loses power, it will automatically default to stored settings.*

Using the Keypad

button until the "PROGRAM" illuminates.
button while watching the lower pump unit. Release the COUNTER
button while watching the lower pump unit. Release the CLOCKWISE
button and put unit into the desired "Run" mode.
Turns unit clockwise
when programming
Eco-Mode runs 24 hours
on and 24 hours off
Rotates 1 degree every
10 seconds
Rotates 1 degree every
4 minutes
Cycles through
programming and run

Advertisement

loading
Need help?

Need help?

Do you have a question about the HydroSweep Pro and is the answer not in the manual?