Page 1
tVNS device for Non-invasive stimulation of the Vagus Nerve...
Page 2
hello Welcome to your new tVNS device This guide shows you how to use tVNS (transcutaneous vagus nerve stimulation) therapy, helps you setup your device, and gets you on a treatment schedule you can use every day. Two AA alkaline batteries are included so you can start straight away.
Page 5
Quick Start Guide 1. Insert the two AA alkaline batteries Take care in doing this, be careful not to strip the material covering the batteries as this can lead to a short circuit 2. Plug the lead included into channel 1 3.
Page 6
(a) Pulse Rate = 2 0 Hz (b) Pulse Width = 2 00 µ s (c) Intensity = S ee section below (d) Time = 1 0 Minutes Mode: C onst Waveform = 1. Adjust the settings with the corresponding +/- buttons to match the display shown above.
Page 7
Setting Up Intensity (c) Repeat for each treatment session 1. Firmly connect earclip to left tragus (See image on p.4). 2. Press the ON/OFF key where settings will display on the LCD screen. 3. Slowly increase the intensity by 1 increment at a time to the point where a tingling is felt on the tragus, going to a ...
Page 8
Safety The Parasym device and ear-clip electrode are CE approved and pose no patient risk if used correctly. ● For safety, intensity s hould not be set above 25mA for treatment. It is also important that stimulation intensity is not raised to the level where there is pain or discomfort on the tragus for an extended period.
Page 9
You can arrange the lead behind your neck (as shown in the image on page 4), this will help take the weight off the connection, increasing mobility. If you have further questions regarding treatment, the device, settings or other queries, please get in touch: contact@parasym.co...
Need help?
Do you have a question about the Parasym and is the answer not in the manual?
Questions and answers